Filter
Top Products
24
Setting a signal
If you want the machine to signal when the wash is complete, you can program it to do this.
The machine is set without a signal by default.
1. Switch off the dishwasher with the main switch.
2. Hold in the Delayed start button at the same time as you press the main
switch. The button flashes. Release the button.
PROG PROG
3. Press the Program button – when the Intensive wash symbol lights up, the
signal is activated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next time you
want to make a change.
or Reset:
1. Switch off the dishwasher with the main switch.
2. Hold in the Delayed start button at the same time as you press the main
switch. The button flashes. Release the button.
PROG PROG
3. Press the Program button – when the Intensive wash symbol goes out, the
signal is deactivated
START
STOP
4. Press the Start/Stop button and the setting will be stored until next time you
want to make a change.