Filter
Top Products
3. Remove door stop
from fresh food
door with Phillips
screwdriver.
4. Remove bottom door trim by removing
4 Phillips screws. Lift handle corner of
trim and slide toward hinge edge of
door.
5. Remove top door trim by removing 4
screws*. Lift handle corner of trim and
slide toward hinge edge of door.
• Retain all screws for later use.
6. Reverse handle by removing two
screws* from top and bottom edge of
handle and reattaching handle on
opposite side of door.
7. Install top door trim on bottom side
of door, and bottom trim on top side
of door.
• Locate hinge hole corner of trim.
Install hinge hole corner of trim on
hinge side first, then install handle
edge of trim.
8. Proceed to How to Replace the
Doors and Hinges (page 7).
5
How to reverse the
doors
STANDARD DOOR DESIGN
1. Perform all steps listed in How to
Remove the
Doors and Hinges
(page 4).
2. Transfer cabinet
plugs and cabinet
screws to opposite
side of cabinet.
• Remove cabinet
plugs with flat
blade of screw-
driver tip wrapped
in masking tape.
• Remove center mullion screws with
5
⁄16" hex head screwdriver.
• For swing doors only: Remove
bottom mullion screws with
3
⁄8" hex
head driver.
3. Transfer door stops from bottom edge
of fresh food door and freezer door
(some models) to opposite side of
door edge.
• Use a Phillips
screwdriver for
removal and
installation.
4. See How to Install and Remove
Handles (page 6) to remove and
reinstall handles.
5. Proceed to How to Replace the
Doors and Hinges to mount doors
(page 7).
To avoid possible injury and damage
to property:
➢ Place doors on a nonabrasive
surface protected by towels or rugs
while working directly on doors.
CAUTION
To avoid possible injury and damage
to property:
➢ DO NOT remove sub cap when
removing door trim.
➢ Place doors on nonabrasive
surface protected by towels or rugs
while working directly on doors.
CAUTION
DOORS WITH CURVED
CONTOUR DESIGN
1. Perform all steps listed in How to
Remove the Doors and Hinges
(page 4).
2. Transfer cabinet
plugs and screws to
opposite side of
cabinet.
• Remove plugs with flat blade of
screwdriver wrapped in masking
tape.
• Remove center mullion screws with
5
⁄16" hex head screwdriver. screwdriv-
er.
* Fasteners may require either a T-15 Torx
®
driver or a Phillips screwdriver.
Torx
®
is a registered trademark of Textron Inc.