Filter
Top Products
Meintenence
Oven Door
Leveling Legs
important: The ovendooron a new rangemay feel"spongy"
when itisclosed.Thisisnormalandwilldecreasewithuse.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
itsstructure causing an increased risk of breakage at a later
date.
Storage Drawer
Be sure the range should be leveled when
installed. Ifthe range is not level, turn the
leveling legs, located at each corner of
the range, until range is level.
Oven Light
ANT!-TIP
BRACKET
" LEVELING LEG
To replace oven light bulb:
1. When oven is cool, hold bulb
cover in place,then slidewire
retainer off cover.Important:
Bulb cover will fall if not held
in place while removing wire
retainer.
BULBCOVER
RETAINER
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance bulb.
4. Replace bulb cover and secure with wire retainer.
5. Reconnect power to range. Reset clock.
The storage drawer can be removed to allow you to clean
under the range.
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the secondstop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the first
stop position.
3. Lift drawer up again and push until drawer is closed.
Convenience Outlet
([Canadian models only)
The convenience outlet is located on the
lower left side of the backguard. Be sure
appliance cords do not rest on or near
the surface element. If the surface
element isturned on, the cord and
outlet will be damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged CIRCUlTBREAKER
intoit exceeds 10 amps. To reset the circuit breaker, press the
switch located on the lower edge of the backguard.
7