Filter
Top Products
3
Upper Rack
Glasses, cups, stemware, light-weight plastics, plates,
bowls, pans, long-handled utensils etc. can be loaded
in this rack.
Do not load glasses over the tines.
The Stack-Rack (select
models) on the right side
of the upper rack folds
up or down for loading
flexibility. Fold it down to
hold long-handled
knives, spatulas and spoons or short items like cups or
juice glasses. Fold it up for taller items like glasses,
bowls, plates, etc.
The edge of the
Stack-
Rack (select models) is
designed to hold
stemware in place. Taller
stemware will fit better on
the right side as the upper
rack is deeper on this side.
The
Cup Clips (select
models) located in the
center of the upper rack
can be used to hold
light-weight plastic items,
cooking utensils, knives,
etc. in place. Clip the
item between the tine
and the clip.
Lower Rack
A variety of items such as dinner plates, mixing bowls,
pots and pans and baking dishes can be loaded in this
rack.
Wider items can be placed along the left side and
back of this rack.
Utensil Basket
Removable Standard Utensil Basket
(style may vary)
For best cleaning results, prevent
items from nesting together by
placing some items in the basket
with handles up and some with
handles down. On models with
slotted covers, load knives, handles up and spoons and
forks handles down.
Be sure that thin, finely pointed items do not extend
through the basket. This could block the lower wash
arm.
Auxiliary Basket (select models)
Use this supplemental
basket in the upper or
lower rack for loading
miscellaneous items and
utensils. This is also a safe
place to load sharp knives
and pointed items.
Removing the Upper Rack
The upper rack can be removed when tall or oversized
items need to be loaded into the lower rack. Unload
the rack before removing it from the dishwasher.
To remove rack:
1.
Roll the rack
1
⁄3 to
1
⁄2 of the way out.
2. To remove each plastic push tab rack stop from the
end of each track, push inward (toward the rack) on
the ridged area of the rack stop. The rack stop will
snap open and can be easily removed by pulling
straight out. Take care to support the track while
removing rack
stops.
3. Roll the rack all
the way out of the
track and remove
from the
dishwasher.
To replace:
• Reverse the above
procedure to replace the rack into the dishwasher.
Important
The dishwasher will not
operate correctly if the
wash arm is not aligned
with one of the water inlet
holes on back wall of the
dishwasher.
Loading
Push Tab
Rack Stop