Filter
Top Products
6
Cycles, Options and Lights
Lights/Display
Delay
The Delay option can be used to automatically start
the cycle at a later time to reduce daytime heat
buildup in the home or to take advantage of reduced
energy costs if available in your area. This option is
also useful for conserving hot water at times of high
household usage (showers, laundry).
To set up a Delay:
1.
Select the appropriate cycle and options for the
load. Close the door.
2. Press the Delay pad until the desired amount of
delay time is selected.
3. The Delay indicator and the count down display
(select models) will flash until the
START/Cancel
pad is pressed.
4. As soon as the START/Cancel pad is pressed, the
flashing will stop and the delay time will begin
counting down. The
Delay indicator will remain lit
until the delay time has counted down.
5. The cycle will automatically start as soon as the
delay time expires.
Note
• If 30 seconds elapse between setting the cycle
and options and pressing the
START/Cancel
pad, the dishwasher will turn off.
To cancel a Delay:
When the delay is counting down, press the Delay pad
again. The indicator light will go out and the cycle will
start or resume immediately.
To cancel a Delay and the cycle:
• Press START/Cancel once to drain and turn off the
dishwasher.
Or
• Press
START/Cancel twice to turn dishwasher off
without draining.
Lights/Display (select models)
INDICATOR DESCRIPTION
CLEAN Light
WASH/DRY Light
SANITIZED Light
(select models)
Illuminates at the end of the cycle and remains lit until the door has been open for 30 seconds
continuously.
Illuminates during all rinse, wash and dry portions of the cycle.
Illuminates at the end of the cycle when conditions have been met to achieve sanitization. The light will
remain lit until the door has been open for 30 seconds continuously.
Notes
•When Sanitize is selected, cycles are monitored to assure sanitization. The SANITIZED light will not activate if sanitization
requirements are not met. This could happen if the cycle is interrupted, power failure occurs or incoming water
temperature is below 120° F (49° F).
•The CLEAN and SANITIZED indicator lights (select models) will not relight after a power failure until after the next cycle is run.
Most tableware, cookware and flatware can safely be washed in your dishwasher. Check with the manufacturer.
What Can and Cannot Be Washed
Yes, except anodized.
No
Yes, except antique or
hand-painted.
Yes, except antique or
delicate crystal.
Not recommended.
High water temperature and detergents may affect finish.
Seasoning will be removed, and iron will rust.
Always check manufacturer’s recommendation before washing. Antique, hand-
painted or over-the-glaze patterns may fade. Gold leaf may discolor.
Always check manufacturer’s recommendation before washing. Some types of
leaded crystal may etch with repeated washings.
May leave a dingy deposit or stain on dishwasher interior.
Crystal
Cast Iron
Aluminum
China/Stoneware
MATERIAL DISHWASHER SAFE? SPECIAL INFORMATION
Filters
Cont.