Filter
Top Products
INSTALLATION
t:lemo_e and discard the cantilever shelf packing clips if the t]oor is not level and it is neeessary to raise the
located just above eaeh shelf where it books onto the rear of thc cabinet, we suggest, rollin(r the rear wheels
fi'ame. To remove the plastic clips, wiggle the clips onto apiece ofpI)weod or other shim materiah
sideways and pull straight ont.
4. To replace, center the clips in the cut-out areas and
Locating Your Refrigerator pnsh in until the hase grille snaps into place.
1. Allow a free l]uw of'air through the front base grille. Connecting the Appliance
9. "llmr model should not be installed where the room
tel'llperature will go below 55° E, because it will not WARNING,: This app]ianee is designed to operate
run frequent b, enough to maintain proper on a normal I15 volt, 15 amp, 60 c)cle line. There
temperature in the freezer, should be a separate, grounded circuit serving this
:3.For ease of installation, ,v°u should leave a space of" appliance only. Do not use an extension cord•
about 1/2 inch between the refi-igcrator and adjacent This appliance is equipped with a three-pronged
walls or cahinets. If"the refrigerator is placed _@h the
gronnding plug for yoJtr protection against pnssihle
hinge side against a wall, you may want to leave electrical shock hazards. It nmst he plugged into a
additional space so the door can be opened wider, grounding receptacle. Where a standard two-prong wail
(Refer to the installation instructions for more
detail.) receptacle is encountered, it is the personal
responsihilit) and obligation of the cnstomer to have it
Important Leveling Information replaced with a properly grounded three-prong wall
Your refrigerator is equipped x_4thfront and back rollers receptacle. Do not under an_ circumstances, cut or
remove the third (grotmd) prong t)comthe power cord.
so it can be moved myra' front the wall fur cleaning. The
front rollers are a@tstahle and shonld he positioned so Do no_ rise an adapter plug.
the refrigerator sits firmh' on the flonr and is level.
To adjust the front rollers: /_
l. Hemnve the hase grille by grasping the ends, Iif}and
)ul] out. ®
: [ Energy Saving lips
1. Locate the refrigerator away from heat producing
2. To ]exel the ret_'igerator, use a screwdriver and turn appliances sueh as the range or dishwasher, heat
roller adjusting screws elocka_dse to lower the cahinet vents and direct sunlight.
or countereloeka_dse to raise the cabinet. 2. Level the refrigerator and do not Nock xentilation
around the front grille.
3. Keep the freezer full to near capacity so less cold air
will escape during door openings. When less than
two-thirds full, place milk cartons half fhll of water in
the freezer.
4. Let hot dishes cool slightly before putting into the
refrigerator or freezer.
TURN CLOCKWISE TO
LOWER CABINET CORNER. 5. Cover liqnids.
TURN COUNTER-
CLOCKWISE TO RAISE 6. Wipc moisture fron-t the ontsidc of containcrs he}ore
CAmNETCORNER. placing them into the refrigerator.
3. It is not necessary tn lock the refrigerator in place. 7. Avoid opening the doors too often.
However, if that is desirable, turn one or both of the
locking tSet elockavise. The) are located near the
front wheels.
PAGE 1