Filter
Top Products
3
INSTALLATION,CONT.
Door Adjustment
(IF NEEDED)
• Retighten screws after making
adjustments.
* Refer to installation instructions for
more information.
Door should be level when the cabinet is
level.
• The freezer door is too high.
•Both doors are too high.
•Both doors are too low.
Top-Mount Handle
TOP MOUNT HANDLE INSTALLATION INSTRUCTIONS
TOP OF FREEZER DOOR
ALIGN HANDLE OVER SCREW HOLES.
FIRST INSTALL THE "A" SCREWS TO
SECURE HANDLE, FOLLOWED BY THE
"B" SCREWS.
DO NOT OVER TIGHTEN.
NO.
2
PHILLIPS
SCREW DRIVER
IS REQUIRED
FOR
INSTALLATION.
A
A
B
B
NOTE: ALL HANDLE TIE DOWN
SCREW HOLES AT THE TOP AND
BOTTOM OF THE DOORS ARE SIZED
FOR SELF THREADING SCREWS.
DO
NOT
DRILL THEM TO A LARGER SIZE.
REFRIGERATOR DOOR HANDLE WITHOUT EXTENSION TRIM
ALIGN HANDLE OVER SCREW
HOLES. FIRST INSTALL THE "A"
SCREW TO SECURE HANDLE,
FOLLOWED BY THE "B" SCREW.
DO NOT OVER TIGHTEN.
NO.
2
PHILLIPS
SCREW DRIVER
IS REQUIRED
FOR
INSTALLATION.
INSTALL SCREW IN
HANDLE HOLE.
DO
NOT OVER TIGHTEN.
SNAP EXTENSION INTO
PLACE AT THE BOTTOM
OF THE HANDLE.
A
B
REFRIGERATOR DOOR HANDLE WITH EXTENSION TRIM
NO.
2
PHILLIPS SCREW DRIVER IS
REQUIRED FOR INSTALLATION.
ALIGN HANDLE OVER SCREW
HOLES. FIRST INSTALL THE "A"
SCREW TO SECURE HANDLE,
FOLLOWED BY THE "B" SCREW.
DO NOT OVER TIGHTEN.
INSTALL SCREW IN HANDLE
HOLE.
DO NOT OVER TIGHTEN.
SLIDE HANDLE
EXTENSION OVER
BRACKET AT
BOTTOM OF
DOOR.
SNAP TOP OF EXTENSION
INTO PLACE AT THE
BOTTOM OF THE
HANDLE.
ON CERTAIN MODELS
REMOVE BACKING
FROM TAPE.
AFTER
STEP 5
APPLY
PRESSURE.
A
B