Filter
Top Products
14
15
Please read this instruction manual carefully
and familiarise yourself with your new Wafe
maker before using for the rst time.
Please retain this manual for future reference.
Before rst use
Before you take your new Wafe maker in
use, the heating plates must be wiped over
with a light damp cloth. Hereafter you should
grease the heating plates with butter or frying
oil.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety
precautions should always be followed to
reduce risk of re, electric shock and/or
personal injury, including the following:
- Make sure that the supply voltage in your
home is the same as the voltage marked
on the appliance.
- Only use the appliance on a stable work
surface, away from water.
- Unplug the appliance from the mains
supply when not in use, in case of
malfunction and before and during
cleaning the appliance.
- Never place the appliance or parts of it
near a heat source.
- Do not hold your hands near the hole in
the lid during operation.
- Never immerse the appliance, parts of it or
the plug in water.
- Children should never be allowed to
operate the appliance.
- Do not allow the cord to hang down over
the edge of the work surface as it could
accidentally be pulled.
- Never disconnect the plug by pulling on
the supply cord.
- Should the appliance fail to operate or in
case of any damage contact the importer
for repair. Improper repairs can result in
considerable hazards for the user.
- Never use the appliance if the cord has
been damaged or if the appliance has
been dropped and is visibly damaged, or
functions abnormally.
- The wafe maker is intended for domestic
use only and is not designed for
commercial use. The manufacturer
accepts no liability if
the appliance is used for commercial
purposes or in manner, which does not
comply with the operating.
- The appliances are not intended to be
operated by means of an external timer or
separate remote-control system.
Normal Use
1. Place the wafe maker at a plain
horizontal work surface.
2. Connect to 220-240 V via the plug to the
outlet. The lamp will light up. There may
during the rst heating, occur some
smoke, which is normal.
3. Close lid and wait until the lamp turns off.
Now the wafemaker has the right
temperature.
4. Open the wafe maker, poor down the
dough in the middle of the lower heating
plate, it will spread out when you close
the lid.
5. Close the lid. The lamp will go on and off
during use, which is indicating that the
thermostat is making sure that the plates
has the right temperature.
6. The lid will go up a little during baking,
since the dough will raise. Do not open
the wafe maker during the rst minute
of baking.
7. Now gently open the wafe maker,
carefully loosen the wafe with a plastic
palette or a wooden palette. NEVER use
any metal on the baking plates, because
this will damage the surface. In case
there is used any metal on the baking
plate, the warranty will not be valid.
8. When you are done baking, leave the
wafe maker open, remove the plug from
the outlet. Let the Wafe maker cool
completely down before you clean the
plates with a damp cloth. Do never use
any water or detergent.
UK