Filter
Top Products
PRIOR TO FIRST USE
Before using the kettle for the first time (or
following a long period without use), the kettle
should be boiled 3 times.
1. Read the safety instructions through
carefully.
2. Fill the kettle with water to the maximum
mark and switch it on as described in
"Using the kettle". Allow the water to boil.
3. Pour the water out once it has boiled.
Repeat the process described in points 2-3 three
times.
USING THE KETTLE
1. Open the lid (1) by pressing the release
button (4). The lid can now be removed by
lifting it straight up and away from the
kettle.
2. Pour fresh water into the kettle. The kettle
must be filled to at least the minimum mark
(0.25 l), but no higher than the maximum
mark (1 l) indicated on the water level gauge
(2).
3. If you removed the lid in step 1, reattach
and close it.
4. Place the kettle on its base (3) by
positioning it so the connector on the base
fits into the hole on the underside of the
kettle.
5. Plug the base in and check that it is
switched on at the wall. Whenever the
socket is turned on, the water level gauge
will light up blue.
• Caution! If you press the on switch (5)
before replacing the kettle on the base, the
kettle switches on automatically when
replaced on the base. For safety’s sake,
press the off switch (6) before replacing the
kettle on the base to avoid accidentally
boiling the kettle.
6. Switch the kettle on by pressing the on
switch. The indicator light (7) comes on and
the kettle begins to heat up the water.
The water will boil within a few minutes,
depending on the amount of water in the kettle.
If you want to interrupt the boiling, you can turn
the kettle off at any time by pressing the off
switch. Once the water is boiling, the kettle will
automatically switch off thanks to the integrated
thermostat. The indicator light goes out.
Safety feature for boiling dry
If you switch the kettle on without there being
any water in it or when the water level is below
0.25 l, the safety feature that prevents the kettle
from boiling dry automatically switches the kettle
off. The kettle can be switched on normally as
soon as it is filled with a sufficient amount of
water.
Storage
If the kettle is to be stored for any length of time
without use, the cord can be rolled up around
the inside of the base. Check that the kettle is
clean and dry before storing.
CLEANING
• Before cleaning, remove the plug from the
wall socket and allow the kettle to cool
down.
• Clean the external surfaces of the kettle
with a damp cloth. The kettle must not be
submerged in any form of liquid.
• Make sure that no water gets into the
connector on the base or the hole in the
underside of the kettle.
• Do not use any kind of strong or abrasive
cleaning agent on the kettle or accessories.
Never use a scouring sponge or similar to
clean the kettle, as the surface may be
damaged.
• The kettle’s limescale filter can be removed
by removing the lid, taking hold of the
limescale filter and carefully swinging it
back towards the handle and lifting it out.
Clean the limescale filter with a soft brush.
• The limescale filter is replaced by putting
the pin on the limescale filter into the
corresponding hole inside the kettle and
then carefully pushing the limescale filter
forward towards the kettle’s spout until it
clicks into place.
15
245031_IM 18/04/05 15:00 Side 15