Filter
Top Products
7
Brewing
1. Plug into 120V ~ 60 Hz outlet.
2. Make sure unit is in the OFF position. The Indicator Light will
be off.
IMPORTANT: Place coffee maker on a level surface.
3. Markings on the Water Level Indicator indicate the amount of
water required to brew the desired number of Thermal Mugs.
Lift up the hinged Water Chamber Lid and fill to desired level
with cold, fresh water for the number of Thermal Mugs (one
or two), using the Water Level Indicator on the Water Window.
WARNING: When making one Thermal Mug, do not fill
above level 1.
IMPORTANT: If cream or milk will be added to Thermal
Mugs, use less water for brewing.
4. For optimal holding temperature, rinse the inside of Thermal
Mugs with warm water before brewing. Place Lids securely
on tops of Thermal Mugs. Press down on the Lids to ensure
proper fit.
NOTE: You can brew either one Thermal Mug or two
Thermal Mugs at once. Place Thermal Mugs snugly on
Base of unit as shown in Figure A (for two Thermal Mugs)
or Figure D (for one Thermal Mug). The contoured design
on the Base should be used as a guide for Thermal Mug
alignment.
5. Insert a #2 paper cone filter into the Removable Filter Basket
and add coffee grounds. Use approximately 1-1/2 to 2
tablespoons for each Thermal Mug of coffee. Close Water
Chamber Lid.
6. Press Power Switch ON. The Indicator Light will turn on.
CAUTION: Avoid contact with heated water.
IMPORTANT: Do not remove Thermal Mugs until the
Indicator Light has turned OFF. The Indicator Light will
turn OFF approximately two minutes after brewing is
complete. This delay will allow the last drops of coffee to
flow into the Thermal Mugs.
7. After Indicator Light turns off, Thermal Mugs may be safely
removed.
8. If brewing more than one cycle, allow unit to cool for 10
minutes between cycles.
6
Helpful Hints for Brewing
• Always use fresh, cold water for brewing. In areas with hard
water or where water contains a high mineral content, use
cold filtered water for optimal coffee taste.
•For best results, use Melitta® #2 paper cone filters and
Melitta® Premium Fine Grind Roast Coffee.
• The markings on the Water Level Indicator reflect the quantity
of fresh water to be used. The quantity of brewed coffee is
less because the coffee grounds absorb water.
Care and Cleaning
1. Make sure Power Switch is in the OFF position. The Indicator
Light will be off.
2. Unplug and allow to cool completely before cleaning.
3. Open Water Chamber Lid and lift up on the tab of Filter
Basket. Discard any paper filter and coffee grounds.
4. Remove Flow Nozzle by pulling down away from the Filter
Basket Holder.
5. Wash removable Filter Basket, Drip Tray and Overflow Tray,
Flow Nozzle, Mugs and Mug Lids in warm, soapy water. Rinse
and dry thoroughly. Or, you may wash the Mugs and Lids in
the top rack of a dishwasher.
6. Clean the outside of the coffee maker with a damp cloth.
CAUTION: DO NOT IMMERSE CORD, PLUG OR COFFEE
MAKER UNIT IN WATER OR OTHER LIQUID.
7. Replace Filter Basket, Flow Nozzle, Drip Tray and Overflow
Tray for next use.