Filter
Top Products
11. Do not expose the appliance to
rain or moisture and do not operate
the appliance outdoors or with wet
hands.
12. Use only clean cold water.
13. The appliance operates at very high
temperatures and there is a danger
of scalding from escaping water or
steam. Do not touch any part of the
kettle except the handle (when the
appliance is in use) and ensure that
the lid has been closed properly.
This appliance is designed for heat-
ing up of water only. Never put any
other liquid into the kettle.
14. The appliance must be positioned
so that the plug is accessible.
15. If the kettle is overfilled, boiling wa-
ter may be ejected.
16. WARNING – Do not open the lid
while the water is boiling.
17. The kettle is only to be used with the
base provided.
18. CAUTION – Ensure that the kettle is
switched off before removing it from
its base.
19. This appliance is intended to be
used in households or other similar
environments such as:
• Staff kitchen areas in shops, offices
and other working environments
• By clients in hotels, motels and
other residential type environments
• Farm houses
• Bed and breakfast type environ-
ments
Operating guidelines for first use:
1. Prior to initial use, clean the ap-
pliance by going through several
boiling cycles, using clean water
with each cycle and filling the kettle
(4) to its upper marking. The water
will reach boiling point after ap-
proximately 5 minutes and will then
switch off automatically.
Operation:
(Please refer to Figure 1)
1. Place the cordless base (7) on a firm
and level surface.
2. Pour the desired amount of clean
water into the kettle (4). Do not touch
any part of the kettle except the
handle while the appliance is in use.
Ensure that the lid (1) is properly
closed. The amount of water can be
measured by the level mark on the
outside of the kettle. Always pay at-
tention to the minimum and maxi-
mum levels and ensure that the lid
(1) is properly and firmly closed.
3. Position the kettle in such a way on
the sub base (6) so that the under-
side of the kettle fits precisely into
the contact on the base. Insert the
plug into a wall socket.
4. Put the on/off switch (3) to the ‘1’
position to start the boiling process.
The indicator lamp will light up.
5. As soon as the water reaches boiling
point, the on/off switch (3) will return
automatically to the “0” position. The
indicator lamp will go out. The kettle
can also be switched off manually by
putting the on/off switch to the “0”
position.
6. The hot water may now be poured
safely through the spout.
7. This kettle is equipped with a safety
cut–out feature to protect the appli-
ance from damage in case of inap-
propriate use. Should the appliance
be accidentally switched on without
water or if all the water has evaporat-
ed, the safety cut out will automati-
22400_IM.indd 3 2012/05/24 11:21:06 AM