Filter
Top Products
ly and will automatically control the temperature
in order to cook at a light simmer (below boiling
point). The function will automatically switch the
appliance off after one hour.
‘TIMER’ Function
•‘STIR FRY’, ‘HIGH” and ‘BRAISING’ functions have-
default cooking times.
•The range of the cooking time for The ‘STIR FRY’
and ‘HIGH’ cooking time range is between 1~120
minutes.‘BRAISING’ cooking time can be set be-
tween 10~120 minutes. The other functions do not
havedefault cooking times.
•Press the ‘TIMER’ button to increase the cooking
time by 1 minute, press ‘TIMER’ continuously in
order to increase the cooking time in increments of
10 minutes.
Time Delay Function
•Press ‘FUNCTION’ button and then press the ‘TIM-
ER’ button, the delay time will be increased by 30
minutes each time the ‘TIMER’ button is pressed.
•The range of the time delay is from 30 minutes up
to 24 hours. The “Time Delay” function will start
cooking when the set time has finished counting
down. Press ‘OFF’ button to cancel the function.
•‘SOUP’, ‘PORRIDGE’, ‘LOW’ and ‘MED’ functions
can be used with the ‘Time Delay’ function, while
‘STIR FRY’, ‘HIGH’ and ‘SAUTÉ’ do not have this
function.
•Exercise extreme caution when using this function
and take care not to leave the appliance unattend-
ed during the countdown and especially not when
the countdown has finished as cooking appliances
should never be left unattended while switched on.
•Do not set the “Time delay” and then leave the
house. Ensure that when the countdown has fin-
ished that you are in the room and that your pot is
prepared and on top of the appliance.
“CONSUMPTION” Button
•When the appliance is on press the “CONSUMP-
TION” button to check the amount of electricity that
the appliance has used since it has been switched
on.
•The screen will display the consumption for a min-
ute and then return to what it displayed before the
button was pressed.
Note: The power consumption displayed is for refer-
ence purposes only.
Induction Cooker Maintenance and Cleaning
•Before undertaking any cleaning task, unplug the
power cable from the wall socket.
•Do not unplug the power cable while the induction
cooker is switched on. First, press the ‘ON / OFF’
button to switch off the power before unplugging
the power cable from the wall socket, this will
extend the life of the induction cooker.
Cleaning
• Allow the appliance to cool down completely be-
fore undertaking any cleaning task.
• Clean the appliance regularly.
• Use a soft, damp cloth to clean the appliance, do
not use gasoline or benzene.
• Do not use any abrasive chemicals or materials to
clean the appliance.
• Wipe the body of the appliance with the soft damp
cloth taking care not to use too much water. Do not
allow water to drip from the cloth onto any part of
the appliance.
• Clean the air inlet and outlet periodically with soft
brush or vacuum cleaner as dust may get caught in
the air inlet or outlet, this will extend the life of the
induction cooker.
• Never place the induction cooker under running
water or immerse it in water or any other liquid.
Notice: Switch the power off when the appliance
is not in use. Only clean the appliance once the
cooking surface has cooled down completely. Do
not use the appliance if the surface is dirty, when
the appliance re-heats the dirt will become more
difficulty to remove.
FAULTS DIAGNOSIS AND SAFETY PROTECTION
•E0 Power light on, no cooking pot is on the cooking
surface or the pot is made from unsuitable materi-
als for the induction cooker.
•E1 First light on indicates that power voltage is
below 100v~ (for some models, it is 150v).
•E2 Indicates that power voltage is above 270v
•E3 Second light on indicates temperature detector
of the plate has short circuited or overheated.
•E4 Third light on indicates that the circuit of the
temperature detector is open.
•E5 Fourth light on indicates that the temperature
detector of radiator has short circuited or over-
heated.
•E6 Fifth light on indicates that the circuit of the
temperature detector for the radiator is open.
•Note: E1, E2 will automatically return to normal
operation once the voltage has been corrected.
Safety cut off: When the induction cooker is in use
continuously for two hours without any buttons
being pressed, the appliance will turn off automati-
cally (Unless the time delay function is being used).
46004_IM.indd 4 1/21/2014 4:14:59 PM