Filter
Top Products
5
J Roller Replacement
(Figure 1, 2 & 3)
1. Remove the appropriate side panel. (Section
A)
2. Remove appropriate drive chain. (Section I)
3. Remove the appropriate roller retainer bar
(IMPORTANT: Note proper positioning on
the 4 washers (2 on each stud) located
between the roller retainer bar and the wall of
the unit. These washers MUST be installed
in this position to achieve proper roller
rotation).
4. While holding element terminal upwards to
achieve clearance, slide out roller.
5. NOTE: At this stage of replacement, it is
suggested that the teflon bushings be
inspected for possible wear and replaced if
necessary. (section K)
6. Insert new roller, holding element terminal
end upwards to achieve clearance.
7. Replace roller retainer bar making sure to
place the 2 washers on each weld stud
before replacing retainer bar.
8. Replace drive chain. (Section I)
K Teflon Bushing Replacement
(Figure 1, 2 & 3)
1. Remove appropriate side panel. (Section A)
2. Remove appropriate heating element. (Section
H)
3. Remove appropriate drive chain. (Section I)
4. Remove appropriate roller. (Section J)
5. Working from inside (Motor) side of unit, push
out bushing (Towards cooking surface of rollers)
with a screw driver.
6. New bushings MUST be installed from the
cooking surface side, towards the inside of the
side panel. Be sure the flattened slot on the
bushing is correctly positioned in opening.
7. Replace roller. (Section J)
8. Replace drive chain. (Section I)
9. Replace heating element. (Section H)
ELECTRONIC SPECIFICATIONS FOR 208V/240V MODELS