Filter
Top Products
9
English
DELAY TIME SETTING:
1. Press “DELAY TIME” button. The display will show “0.5” (equals 30 minutes) and the
indicator light will be lit. Repeat pressing ‘DELAY TIME’ until desired amount of delay
time is displayed. Total delay time is 8 hours.
2. Select the desired cooking mode (HIGH, LOW, STEAM, etc.) and time by pressing the
appropriate button(s).
3. Press the ‘START/STOP’ button and the delay time indicator light will turn on. Your
appliance will begin desired cooking after the delay time has elapsed. The time delay
indicator light will turn off.
CLEANING YOUR DIGITAL COOKER
1. Unplug cord from the wall outlet, then the appliance and let the unit cool before
cleaning.
2. DO NOT wash any parts of your appliance in a dishwasher. Use warm soapy water,
rinse and dry. Always clean after each use or if it has not been used for an extended
period of time.
3. Wipe base with a clean damp cloth. NEVER submerge the base in water or other liquid.
Wipe the inside of base as necessary to remove any food product.
4. If the condensation reservoir contains visible moisture, remove by pulling down. Wash
in warm soapy water. Rinse and dry. Attach to base by pushing up to lock into place.
5. Turn the lid upside down, grasp the rubber gasket on either side and pull up. Wash
gasket in warm soapy water. Rinse and dry thoroughly. Insert the rubber gasket by
pushing it down inside the edge of the lid, making sure the ‘v’ groove of the gasket is
centered around the wire ring on the lid. NOTE: If the rubber gasket is not positioned
properly the appliance will not function normally.
6. In order to maintain good performance of your appliance, the bottom of the removable
cooking pot should be cleaned after each use. Wipe with a soft damp cloth and dry
before using.
7. Never use abrasive cleaners or scouring pads to clean any parts of this appliance, as they
will make ne scratches in the surface, especially on the polished surfaces.
8. Store your appliance with the lid resting upside down on the removable cooking pot.
This will protect the valves, knobs and pressure regulator on the top of the lid. If the
appliance is stored with the lid sealed, stale odors may form on the inside.
Cleaning the Pressure Regulator Knob
Check to make sure the pressure regulator knob and oating valve are in good working
order before each use. To clean, please follow the instructions below:
1. After the unit has cooled, remove the lid.
2. Press down and turn the pressure regulator knob clockwise past the SEAL setting and
carefully lift and remove.
3. Turn the lid upside down and set on a tabletop. Pull out the lter by rmly grasping
with a soft cloth lifting upwards. Using a small brush, check and remove any food
particles that may be lodged inside the lter and the oating valve. Push lter back in
place.
4. Replace the pressure regulator knob by lining the notches up to the inside wall of the
pressure regulator chamber in the lid, then press down and turn clockwise to latch.