Filter
Top Products
CHAPTER 3: MRK-1100 RIGGING KIT
12
INSTALLING THE MRK-1100 RIGGING KIT
To install the MRK-1100 rigging kit:
1. Use a 7/32-inch hex wrench to remove the 16 3/8-inch flathead socket bolts from the 1100-LFC (8 on each side of the cab-
inet).
2. Apply 1 or 2 drops of Loctite to each 3/8-inch flathead socket bolt.
3. Secure the four rigging bars to the 1100-LFC cabinet with the 3/8-inch flathead socket bolts. Orient the rigging bars with
the GuideALinks up and the GuideALink knobs facing away from the cabinet.
CAUTION: Make sure the socket bolts are securely tightened but do not over-tighten them. Approximately
15 foot-pounds of torque is recommended.
!