Filter
Top Products
14
OCCURRENCE
Oven Control Beeps and Displays any F
code (for example F11).
Installation.
Entire appliance does not operate.
POSSIBLE CAUSE/SOLUTION
Electronic control has detected a fault condition. Push CANCEL to clear the display and stop
the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number,
push the CANCEL pad and contact an authorized servicer.
Poor installation. Place a level on an oven rack in center of oven. Contact installing agent
if rack is not level.
Kitchen cabinet misalignment may make oven appear to be unlevel. Be sure cabinets are
square and level. Contact cabinet maker to correct problem.
Make sure cord/plug is securely plugged into electrical outlet.
Cord/plug is not installed or connected. Contact your dealer, installing agent or authorized
servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized servicer.
Power outage. Check house lights to be sure. Contact your local electric company.
Short in cord/plug. Replace cord/plug.
Care & Cleaning
Before you call
Solutions to Common Problems
For instructions on how to adjust the oven temperature refer to the electronic oven control guide.
Adjusting Your Oven Temperature
Changing Oven Light
Use the rocker switch located on the control panel to turn the oven light ON or OFF. On
some models, the oven light automatically will turn automatically ON when the oven door
is opened.
Be sure the oven is unplugged and all parts are COOL before replacing
the oven light. Wear a leather-faced glove for protection against possible broken glass.
To Change the Oven Light
1. Turn electrical power off at the main source or unplug the oven.
2. Press wire holder to one side to release the glass shield (some models, Figure 1).
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield in socket and snap wire holder into place (some models, Figure
1).
5. Turn power back on again at the main source (or plug the oven back in).
6. The clock (if equipped) will then need to be reset.
Figure 1 - Single Oven Models
Figure 2 - Double Oven Models
Upper Oven Only