^
Place the bracket on the door panel
so the notches, a, cross the previ
-
ously drawn centerline, and the bot
-
tom of the bracket lines up with the
horizontal X line.
^
Mark and drill pilot holes for the
screws using a
3
/
32
" (2.5 mm) drill bit.
^
Attach the bracket to the back of the
panel, using the 14 screws provided.
The top four pair of holes, only need
to be secured once per pair.
^
Double check the location of the
bracket before mounting the panel to
the dishwasher.
The door handle must be installed on
the panel before it is attached to the
machine. It should be located in the
center of the panel at a height that will
match the surrounding drawer handles.
Any screws used to attach the door
handle must be countersunk so that
the rear of the front panel remains
flat.
Installation
19