Filter
Top Products
Building in the appliance
^ Remove panel a.
^ Secure bracket b with screws c
(4.8 x 16 mm).
^
Attach sealing strip d to the door
opening side so that it sits flush at the
front with the side of the appliance. If
necessary the sealing strip can be
trimmed to size along the lower edge
of bracket b.
^
Push the appliance into its housing
unit.
When doing this, make sure that the
mains cable does not get trapped.
^
Push in the appliance until the front
edges of bracket b and hinge plates
e and f are flush with the front
edge of the housing.
^
Align the appliance height from above
on both sides using adjusting screw
g.
Building in the appliance
43