Filter
Top Products
After changing the jets
^
Reassemble the burner parts in the
reverse order,
^
Check all gas fittings for leaks by
operating the burner without the top
section of the hob in place (use a
match to ignite the flame).
^
Remove the loose burner parts again.
^
Replace the top section of the hob.
^
Screw the parts for the burner bases
together securely, and assemble the
burners (in the correct order!).
^ Replace the control knobs.
^ Ignite all the burners to check that
they are operating correctly.
The flame must not go out on the lowest
setting, or when the control is turned
quickly from a high to a low setting.
On the highest setting, the flame must
have a distinctive and visible core.
^
Stick the label supplied with the jets
above the label stating the type of
gas being used.
Conversion to another type of gas
50