Miele CVA 2662 Coffeemaker User Manual


 
Water tank
Empty the water tank daily, and fill it
with cold fresh water shortly before you
start preparing a beverage.
When cleaning, check to be sure
that there is no debris in or around
the valve. This would prevent the
tank from connecting properly,
causing it to leak.
^
Clean the niche of the water tank.
Waste container
Clean the waste container daily.
Typically there will also be some water
in the container, left over from the
brewing and rinsing processes.
^ Slightly lift the waste container, then
pull it out of the appliance.
^ Wash the container in the
dishwasher, or by hand with a mild
solution of warm water and liquid
dish soap, then dry thoroughly.
^
Clean the waster container niche. Be
sure to clean the sensors, left and
right, the sensors read if the waste
container is inserted and if it needs to
be emptied.
Drip tray with grid
Do not remove the drip tray from the
appliance for a few minutes after the
final rinse, as water will still run from
the lines.
Use caution when removing the drip
tray, the water may be hot. Danger
of burns.
Clean the drip tray daily.
^
Open the appliance door and
carefully remove the drip tray from
the appliance.
^ Wash the drip tray and the grid in the
dishwasher, or by hand with a mild
solution of warm water and liquid
dish soap, then dry thoroughly.
^ Clean and dry the metal sensors at
the back of the drip tray. If the
sensors are soiled or wet the unit
cannot read when the drip tray is full
and needs to be emptied.
^
Push the drip tray, with the grid
inserted, along the right hand side of
the opening and to the back of the
machine.
^
Close the door.
Cleaning and care
39