Miele DA 262 I Ventilation Hood User Manual


 
Cleaning and care
When removing the filters for clean-
ing, also clean off any residues of oil
or fat from the filter housing to pre-
vent the risk of these catching fire.
DA 272 i, DA 292 i only: Put the filters
back together.
When re-inserting the filters ensure
that the locking device faces down
towards the cooktop.
If a filter is inadvertently replaced the
wrong way a round, use a small
screwdriver blade to unlock the filter
through the slots.
Changing the light tube and/or starter
Disconnect the cooker hood from
the mains supply (switch off at the
wall socket and remove plug or the
fuse).
Unscrew the fixing screws at the left
and right hand side.
While doing so, hold the light cover
securely and then take it out.
Release the light tube and the starter
by turning them and then lifting them
out of their holders.
Replace the fluorescent tube or star-
ter.
Inserting or changing the active
charcoal filters.
If the cooker hood is connected for re-
circulation, active charcoal filters must
be inserted, in addition to the grease fil-
ters. These filters absorb normal kit-
chen odors.
Pull out the deflector plate and
remove the rear grease filter.
When removing or changing the ac-
tive charcoal filters, push the filter
holder retainers towards the middle.
When inserting the active charcoal fil-
ters, ensure that the locking device
faces down towards the cooktop.
The active charcoal filters should be
replaced when kitchen odors are not
being absorbed, at least every 3-4
months.
Cleaning and care
11