Filter
Top Products
a 2 hose clips
for securing the vent ducting to the
exhaust socket.
b 1 non-return flap
for fitting into the exhaust socket on
the motor unit (only for air extraction
mode).
Depending on model, the non-return
flap may already be fitted.
c 2 brackets
to support the appliance in the wall
unit.
d 1 spacer strip
to conceal the gap between the rear
of the appliance and the wall.
e Conversion kit for recirculation
mode
including exhaust grille and flexible
aluminium hose (the conversion kit is
not supplied with the cooker hood but
is available as an optional accessory;
see "Technical data").
f DML 300 installation kit (optional
accessory)
contains hinging and screws for
fixing a lightshield to match kitchen
furniture (lightshield not supplied with
cooker hood)
8 screws 3.5 x 16 mm
for securing the cooker hood into the
wall unit.
8 screws M4 x 12 mm
for securing the cooker hood to the
brackets.
4 of the screws can be used instead of
the plastic rivets to secure the spacer
strip.
2 screws4x30mm
for securing the cooker hood at rear wall.
4 plastic rivets
for securing the spacer strip to the
back of the appliance.
Installation
23