Filter
Top Products
Installation work and repairs to
electrical and plumbing components
of this appliance must only be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
What to do if ...
... you hear a humming sound when
the appliance is switched on, during
operation or after the appliance has
been switched off.
This sound does not indicate a
malfunction or fault with the appliance.
It happens when the water is pumped
in and out.
... the appliance beeps after the start
of a programme, and the word "door"
appears in the time display.
The door has not been closed properly.
... the mains fuse has tripped.
Reset the trip switch in the mains fuse
box, and switch the appliance back on.
If it still cannot be operated, contact a
qualified electrician or the Miele Service
Department.
... the appliance does not heat up.
Check whether the Demonstation mode
has been set (see "Programming").
... condensation collects on the
outside of the oven door.
This is not a fault. With a certain
temperature range, steam released by
the pressure regulator condenses
inside the double-walled door of the
appliance, and trickles out near the
door hinges.
... the appliance is locked during a
prolonged power cut and you want to
remove the food from it.
Caution: the appliance will still be hot
and under pressure.
Pull out the shelf. Then using the thumb
of your right hand, push the door lock
forwards slowly a little bit at a time.
Caution! Steam will escape from above
and below the door hinge.
Open the door very carefully. Danger of
scalding with hot steam.
Problem solving guide
51