Filter
Top Products
The bracket includes a variety of holes
for the various design options of
custom doors.
When performing work on the custom
door, always observe the following:
–
Always select the best load-bearing
surface of the custom door as the
location for screws.
–
Always select a screw length that is
shorter than the thickness of the door
front.
Attaching and aligning the
custom door front
^ Fit the door handle to the custom
door. Note that the screws are
applied from the reverse side.
^
Open the door and hang the custom
door with the adjusting rail over the
double-threaded bolts p.
^
Screw the nuts q a few turns onto
the double-threaded bolts. Do not
tighten completely.
^
Close the door.
^
Adjust the custom door to adjacent
furniture/fixtures.
^
Align the custom door with the
double-threaded bolts.
^ Tighten the nuts on the adjusting rail.
This will correct the side alignment of
the door.
^ Put the side strips o back into place
and screw them completely down on
both sides of the appliance door.
Bag E contains spare screws for this
purpose.
^
Align the custom door again as
needed and tighten all screws on the
sides.
Installing the appliance
70