Filter
Top Products
Once the drip tray has been removed,
the four aligners can be accessed to
adjust the Ice/Water Dispenser to your
liking.
^
Loosen the screws of the four
clamps.
^ Insert a screwdriver into one of the
four slots and push sideways until the
dispenser is aligned with the custom
door (the gray arrow will adjust to the
rear; the black arrow will adjust front).
^ Re-tighten the screws of the clamps.
^ Insert the drip tray back into place,
then clip the water sensors back onto
the drip tray.
^
Replace the rear cover, panel and
screw.
^
Replace the drip tray and cover.
^
Finish by putting the plastic grill,
cover, and dispenser back into
place.
Attaching the frame and the
shelf
For
3
/
4
" (19 mm) thick custom doors:
^ Slide the cover frame onto the
Ice/Water Dispenser and press until it
is flush with the door surface (be sure
the word "TOP" on the cover frame is
upward).
For 1
1
/
2
" / (38 mm) thick custom doors:
^ Press the extension frame onto the
cover frame.
^
Slide the cover frame onto the
dispenser an press until it is flush
with the door surface (be sure the
word "TOP" on the cover frame is
upward).
^
Insert the cover frame.
Installing the appliance
75