Filter
Top Products
^ Mark the distance X on the back-side
of the custom door.
^ Also calculate and mark the center of
the custom door Y.
^ Remove the mounting frame from the
appliance door and position it
according to the markings on the
custom door.
^
Pre-drill the holes.
^
Tightly screw on the bracket using
the pre-drilled holes:
Attach the bracket to each
attachment point with at least one
screw.
^
Attach the bracket at the top with at
least 6 screws.
The bracket includes a variety of holes
for the various design options of
custom doors.
When performing work on the custom
door, always observe the following:
–
Always select the best load-bearing
surface of the custom door as the
location for screws.
–
Always select a screw length that is
shorter than the thickness of the door
front.
Attaching and aligning the
custom door front
^ Fit the door handle to the custom
door. Note that the screws are
applied from the reverse side.
^
Open the door and hang the custom
door with the adjusting rail over the
double-threaded bolts p.
^
Screw the nuts q a few turns onto
the double-threaded bolts. Do not
tighten completely.
^
Close the door.
Installing the appliance
69