Filter
Top Products
^ Pull the rear cover forward and out.
^
To remove the drip tray, begin by
carefully unclipping the water
sensors, then bend them gently
upward.
Once the drip tray has been removed,
the four aligners can be accessed to
adjust the Ice/Water Dispenser to your
liking.
^
Loosen the screws of the four
clamps.
^
Insert a screwdriver into one of the
four slots and push sideways until the
dispenser is aligned with the custom
door (the gray arrow will adjust to the
rear; the black arrow will adjust front).
^ Re-tighten the screws of the clamps.
^ Insert the drip tray back into place,
then clip the water sensors back onto
the drip tray.
^ Replace the rear cover, panel and
screw.
^
Replace the drip tray and cover.
^
Finish by putting theplastic grill,
cover, and dispenser back into
place.
Installing the appliance
74