Filter
Top Products
^ Stick the sealing strip to the side of
the appliance on which the door is
opened.
Building in
^
Push the appliance into the niche.
Make sure that the mains cable does
not get trapped.
^ Remove cover piece a if the niche
height is not much greater than the
height of the appliance.
^ Push the appliance into the niche
until the front edges of the hinge
plates b are flush with the front edge
of the housing unit above and below.
The upper edge of the cover piece
must not lie against the edge of the
housing unit.
^
Push the appliance against the
housing wall on the side on which the
door opens so that the sealing strip is
pressed into the housing wall c.
Building in the appliance
34