Miele F 456 i-3 Freezer User Manual


 
Building in the appliance
^
Push the appliance into its housing
unit.
When doing this, make sure that the
mains cable does not get trapped.
^
Depending on the thickness of the
appliance housing unit walls, push
the appliance into the niche until
– the spacer piece touches the
housing unit wall a (16 mm thick
walls), – or the front edges of the
hinges are flush with the side walls of
the housing unit b (19 mm thick
walls).
The cover strip must not protrude in
front of the edge of the housing unit.
It must disappear completely into
the niche.
^
Push the hinged side of the
appliance to the furniture wall.
^
Align the appliance by altering the
height of the adjustable feet using the
spanner supplied f.
^
Secure plastic bracket c to the side
opposite the hinges using the M5 x
22 screws d.
^
Push the appliance in until the plastic
bracket is flush with the front edge of
the housing unit floor e.
^
To fix the appliance to the housing
unit at the top and bottom
screw the 4 x 19 mm long chip board
screws a loosely into the hinge
plate,
Building in the appliance
40