Miele F 456 i-3 Freezer User Manual


 
screw two 4 x 19 mm long chip
board screws b loosely into the
middle of the long slot on the plastic
bracket and then turn the plastic
bracket downwards,
Align cover strip d so that it is
parallel to the housing unit ceiling.
It must not protude.
Fit screws c into cover strip d.
^
Close the appliance door.
Fitting a furniture door
^
A gap of 8 mm a must be set
between the appliance door and the
fixing bracket.
^
Push fitting aids d up to the height of
the furniture door: the lower edge "X"
of the fitting aids must be at the same
height as the upper edge of the
furniture door being fitted - see - on
the diagram.
^
Undo nuts b, and remove fixing
bracket c, together with the fitting
aids.
^
Using a pencil, mark a line down the
centre of the wrong side of the
furniture door.
^ Hang the fixing bracket with the
fitting aids a onto the wrong side of
the furniture door. Align the fixing
bracket centrally.
^
Attach the fixing bracket securely
using at least 6 short 4 x 14 mm chip
board screws b. (On cassette doors
only use 4 screws on the edges).
^
Pull the fitting aids upwards to
remove them c.
^
Turn them round and fit them back
into the middle slots on fixing bracket
d.
Building in the appliance
41