Filter
Top Products
Buzzer
A signal sounds at the end of a
program and when a fault occurs.
The buzzer at the end of a program
sounds five times in quick succession
for up to one hour.
The buzzer for a fault sounds in
intervals up to two minutes.
The buzzer is activated by default. It
can be turned off, so it does not sound
at the end of a program. The buzzer for
a fault cannot be turned off.
^ Open the door.
^ Turn the dishwasher off with "o".
^ Press the "Program" button and at the
same time turn the dishwasher on
with "g".
^ Hold the program button until the
lower right program indicator comes
on.
If it does not come on, start over.
^
Press the "Options" button four times.
The "Tab" indicator flashes four times in
intervals.
The time display shows if the program
end buzzer is turned on or off.
–
"p1": Buzzer is turned on
–
"p0": Buzzer is turned off
^
Press the "Program" button to change
the setting.
The setting is saved.
^
Turn the dishwasher off with "o".
Default settings
All settings can be reset to the factory
default.
^
Open the door.
^
Turn the dishwasher off "o".
^
Press and hold the "Program" button
and at the same time turn the
dishwasher on "g". Hold the "Program"
button until the lower right program
indicator comes on.
If it does not come on, start over.
^
Press the "Options" button 12 times.
The "Tab" indicator flashes once long
and twice short in intervals.
The time display shows if a setting was
changed.
–"p1": All settings are factory default.
–"p0": At least one setting was
changed.
^ To reset the dishwasher to the factory
default, press the "Program" button.
The setting is saved.
^
Turn the dishwasher off "o".
Additional options
33