Filter
Top Products
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the
On/Off button s.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button s.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Delay start button three
times.
The "Delay start" indicator will flash
briefly three times at intervals.
p 3 will flash in the display.
This means that the rinse aid dosage
has been set at 3 ml at the factory.
The dosage set will show in the display
after the p.
^
Use the Start/Stop button to select
the rinse aid dosage you want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the
On/Off button s.
Before using for the first time
20