Filter
Top Products
Issue Possible fault Solution
Dishes are not dry,
glasses and cutlery
are spotted.
The rinse aid setting may be
too low, or the rinse aid
reservoir is empty.
Increase the dosage, refill
the reservoir or switch the
rinse aid product when
refilling, see "Before using
for the first time".
Dishes were taken out too
soon.
Leave dishes in longer, see
"Use".
A "Tab" product was used.
These products have a low
drying effect.
Set the Detergent setting for
a normal (powder or gel)
detergent and add rinse aid.
The "Tab" setting is turned
on, but a normal (powder or
gel) product was used.
Set the Detergent setting to
the detergent used, see
"Additional options - Tab".
White residue is
visible on cutlery
and dishes.
Clouding occurs on
glassware and film
can be wiped off.
Not enough rinse aid was
used.
Increase the dosage, see
"Before using for the first
time".
The salt container is empty. Refill the salt container, see
"Before using for the first
time".
The salt container lid was
not correctly screwed on.
Reseat it making sure it
screws back on correctly.
Unsuitable "Tab" products
were used.
Change detergent, use
normal (powder or gel)
detergent.
The water softener is
programmed on too low a
setting.
See "Before using for the
first time".
Frequently asked questions
55