Filter
Top Products
Turning on
^
Make sure the spray arms can rotate
freely.
^
Close the door.
^
Open the water supply, if closed.
^
Turn the dishwasher on "s".
The "Start/Stop" indicator flashes and
the indicator of the last program run
lights up.
Selecting a program
Choose your program according to the
type of load and soiling.
The "Program guide" describes the
programs and use.
Starting a program
^ Select the desired program with the
"Program" button.
The indicator of the selected program
lights up.
^
Press the "Start/Stop" button.
The program starts. The indicators
"Start/Stop", "Rinse" and the last
selected program light up.
Cancel a program only within the
first few minutes. Otherwise
important program steps could be
interrupted.
Program sequence display
After a program has been started the
current stage of the program is
indicated by the program cycle
indicator.
Standby
DA few minutes after the last key is
pressed or at the end of the program
the dishwasher will switch into Standby
mode to save energy. The display and
the indicators are turned off and only
the Start/Stop indicator light flashes
slowly.
^ To turn the display back on press the
Start/Stop button.
If refill salt and/or rinse aid or a fault
are present in the display, the
dishwasher will not switch to
Standby mode.
Use
26