Filter
Top Products
Optimize standby
A few minutes after the last key is
pressed or at the end of the program
the dishwasher will switch into Standby
mode to save energy. The display and
the indicators are turned off and only
the Start/Stop indicator light flashes
slowly.
If the dishwasher is not turned off after
the program ends, it will turn
completely off after a few minutes in
standby mode.
This function can also be turned off.
The display and the indicators stay on
and the dishwasher will turn off after
approx. 6 hours.
^ Select the desired setting and press
the center button.
If refill salt and/or rinse aid or a fault
are present in the display, the
dishwasher will not turn off.
The refill messages can be turned
off when you use a tab detergent.
Fault messages cannot be turned
off.
Deactivate indicators
If you consistently use "Tab" detergent
products in your dishwasher, you can
switch the Salt and Rinse Aid indicators
off if desired.
^
Select the desired setting and
confirm with the center button.
If you switch to using a detergent
that does not contain salt or rinse
aid, remember to replenish the salt
and rinse aid and turn the indicators
back on.
Soak
You can use the Soak function in the
program selected for loosening very
stubborn food residues. It is not
available for every program.
If you are using powder dishwasher
detergent, add approx. 1 teaspoon
(5 g) to compartment I.
^ Select the desired setting and
confirm with the center button.
Once set, the function will remain active
for the programs for which it is
available, until the setting is changed.
Settings menu
45