Miele G 7856 Dishwasher User Manual


 
Water in the wash cabinet is not
heated / the program sequence lasts
too long
This machine has a resettable heater
limiter which will switch off the heaters
in the case of over-heating. This could
be caused, for example, by large
articles obscuring the heating elements
or when the filters in the wash cabinet
are blocked.
^
Remove the cause of the fault.
^
Take off the service panel (see
"Electrical connection").
^
Press the reset button on the heater
limiter (yellow) located on the left-
hand side of the plastic cover.
If this switch trips again, please
contact the Miele Technical Service
Department.
Correcting minor faults
42