Filter
Top Products
Turning on and off / Regulating
The control knob is used to turn on the
burner and to regulate the strength of
the flame.
Turning on
^ To turn on the burner, press the
control knob down and turn it
counterclockwise to the largest flame
symbol. The ignitor will click and
ignite the gas.
^ When the flame appears, keep the
control knob pressed in for
8-10 seconds to allow the Ignition
Safety Control to reach operating
temperature. Release the knob.
If the flame goes out, repeat the above
procedure, keeping the control knob
pressed in for a few extra seconds.
^
Release the knob and adjust it to the
desired setting.
Regulating the burners
The inner and outer burners are both
controlled by one control knob. There is
a stop at the 6 o’clock position that
requires you to press the knob down
while turning it in order to get from the
high flame to the low flame zone.
^
To reduce the flames from a high to
low setting, turn the control knob
counterclockwise until you feel
resistance. Press the knob down to
pass the stop, then release the
pressure and set the cooktop to the
desired setting.
^ To increase the flames from a low to
high setting, turn the control knob
clockwise until you feel resistance.
Press the knob down to pass the
stop, then release the pressure and
set the cooktop to the desired
setting.
Using the cooktop
10