Filter
Top Products
. . . the microwave / heating functions
but not the interior lighting.
^
Check whether the oven interior light
-
ing has been switched off, (see "En
-
ergy saving functions").
If this is not the case, the halogen bulb
needs replacing.
Replace with a new one as follows:
Disconnect the appliance from the
electricity supply, (switch off and un
-
plug at the socket, or remove the
fuse, or switch off at the isolator as
appropriate).
^
Loosen and remove the lamp covers
(1.). This may be easier using a rub
-
ber glove.
^
Take out the halogen lamps (2.).
Exercise caution when changing a
light bulb. Halogen lights get very hot
during use and will remain hot for
some time after being switched off.
^
Do not touch the surface directly
when changing the bulb as grease
particles from your fingers will adhere
to the surface and damage it. Please
follow manufacturer’s instructions.
^
Fit new halogen lamps.
Connection data for halogen lamps:
12 V, 10 W
Temperature resistant to 300 °C,
W271 socket, Osram, Type 64418
The pins must lie horizontally to the ap-
pliance. Push the lamps in until they en-
gage.
^ Screw the lamp cover back on.
^ Reconnect the appliance to the
mains supply.
. . . the food is not sufficiently heated
or is not cooked at the end of a set
time
^
Check whether:
–
the cooking process has been inter
-
rupted and was not restarted,
–
if cooking / reheating in microwave
mode the correct time was selected
for the setting chosen.
A lower power setting normally re
-
quires a longer time.
Problem solving guide
73