Filter
Top Products
Replace the halogen lamp:
12 V, 20 W,
heat resistant up to 300°C, G4
socket, Osram, Type 64428.
Exercise caution when changing a light
bulb. Halogen lights get very hot dur-
ing use and will remain hot for some
time after being switched off.
Do not touch the surface directly when
changing the bulb as grease particles
from your fingers will adhere to the sur-
face and damage it. Please follow the
manufacturer’s instructions.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
. . . no noise is heard when the oven
door is opened during operation (de-
pending on model).
This is not a fault.
If the door is opened during operation,
the door contact switch causes the
oven heating, and the fan if on "Fan"
setting, to be switched off.
. . . a noise is heard after baking,
roasting or grilling.
This is not a fault.
The cooling fan continues to run for a
short time after the oven has been
switched off, to prevent any humidity
building up in the oven, on the control
panel or in the housing unit. When the
temperature has fallen sufficiently the
fan switches off automatically.
The temperature will fall faster when the
oven door is opened partially or fully.
. . . spots like rust appear on cata-
lytic surfaces.
When roasting on the rack, the circulat-
ing air sometimes picks up spices,
which are then deposited on the oven
interior walls. Such residues are not
removed by catalytic cleaning, they are
best removed while fresh with a mild
washing up liquid solution and a soft
brush.
. . . cakes and biscuits are not
cooked after following the times
given in the chart.
Check whether,
the correct temperature was set.
there has been a change to the
recipe. The addition of more liquid or
more eggs makes a moister mix
which would need longer to cook.
the roasting filter had been left in
place in front of the fan when cook-
ing with "Fan Heat D" or was in
place for Auto Roast E. In this
case baking times might be leng-
thened by 10 to 15 minutes.
Correcting minor faults
52