Filter
Top Products
Problem Possible cause and remedy
A fault code
appears in the
displayF+a
number
You can rectify the following faults yourself:
–
Fault 23: The temperature required for pyrolytic cleaning
was not reached.
This could have been caused by too much soiling in the
oven to start with.
Remove all coarse soiling before starting the pyrolytic
cleaning programme again.
If the fault message appears again please contact the
Miele Service Department.
–
Fault 32: The door has not locked for the pyrolytic
cleaning process.
Switch the oven off and start the pyrolytic cleaning
process again.
If the fault code appears again call the Miele Service
Department.
– Fault 33: The door lock for the pyrolytic cleaning
process will not open.
Interrupt the pyrolytic cleaning programme by switching
the oven off. If the door will still not open please contact
the Miele Service Department.
– Fault 55: Safety switch-off has been triggered.
The appliance will be ready for use again after it has
been switched off and then back on again.
For all other fault codes please contact the Miele Ser
-
vice Department.
Problem solving guide
64