Filter
Top Products
In the following illustration the lower
door is not shown in the closed
position to make it easier to see
what happens next.
^ Turn door support d around, pull
hinge pin e out, and refit on the
opposite side.
^
Fit both parts into hinge plate f. To
do this push hinge pin e through
hinge plate f into door support d.
Swing the door support in, push
upwards and re-assemble with screw
c.
^
Align the lower door with the
appliance housing using the long slot
in hinge plate f. Then tighten screw
c.
^
Refit plinth fascia a, pushing it firmly
into position.
^
With the lower door open, secure
cover b to the front of the plinth
fascia.
Refitting the handles:
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws b.
Mounting plate c must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^
Tighten both grub screws a with the
allen key provided until mounting
plate c lines up correctly.
^
Then tighten all 4 fixing screws b.
^
Slide the side section of the handle
d into the guides on the mounting
plate until it clicks into place.
Changing the door hinging
44