Miele KM 5758 Cooktop User Manual


 
Touch controls
The control panel on your ceramic
cooktop is equipped with electronic
sensors. They respond to a finger
touch.
To operate the burners, simply touch
the corresponding sensor area(s). Each
time a command is registered, a signal
will be heard.
Be sure to touch only the desired
sensor area and keep the control
panel clean and clear. Otherwise,
the touch controls may not respond,
or unintentional commands may be
given, even causing the cooktop to
switch off automatically (see the
section on "Safety cut-out feature").
NEVER place hot cookware on the
sensor areas. The electronics can
be damaged.
Turning on the cooktop
^
Put a pot or pan on the desired
burner.
^
Touch the ON/OFF "s" cooktop
touch control.
You will see a dash - in each of the
burner displays, and the On/Off
indicator will light. If a setting is not
chosen within a few seconds the
cooktop will turn itself off as a safety
measure.
Turning on a burner
^ Touch the s On/Off touch control for
the desired burner.
The respective burner display shows 0.
^ Select a power level between 1 and 9
by pressing the + or - control.
When turning on the cooktop you can
decide whether you want to cook with
auto heat or not. See "Auto-heat" for
more information.
Turn on with + to:
cook without auto-heat.
Turn on with – to:
cook with auto-heat.
Use
17