Miele M 613 G Microwave Oven User Manual


 
Before connecting the appliance,
ensure that it has not been damaged
in any way. Do not use a damaged
appliance.
Electrical connection U.K.
All electrical work should be carried out
by a suitably qualified and competent
person in accordance with national and
local safety regulations.
The appliance is supplied with a cable
and moulded plug ready for connection
to a 230-240 V/50 Hz a.c. single phase
supply.
The voltage, rated load and fusing are
given on the data plate which is located
externally on the rear wall of the
appliance. Please ensure that these
match the household mains supply.
Connection should be made via a fused
connection unit or a fused plug and a
suitable switched socket which
complies with national and local safety
regulations, and the on/off switch
should be easily accessible after the
appliance has been installed.
If the socket is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
When switched off there must be an
all-pole gap of 3 mm in the isolator
switch (including switch, fuses and
relays acc. to EN 60335).
For extra safety it is advisable to install
a residual current device with a trip
current of 30 mA (in accordance with
DIN VDE 0664, VDE 0100 Section 739).
If the appliance is connected via an
isolator switch the plug must be cut off
and rendered useless.
Important
The wires in the mains lead of this
appliance are coloured in accordance
with the following code:
Green/yellow = Earth
Blue = Neutral
Brown = Live
If the colours of the wires in the mains
lead of this appliance do not
correspond with the markings
identifying the terminals in your plug,
proceed as follows:
The wire coloured green and yellow
must be connected to the terminal in
the plug which is marked with the letter
E or by the earth symbol z or coloured
green or green and yellow.
The wire coloured blue must be
connected to the terminal marked with
the letter N or coloured black.
The wire coloured brown must be
connected to the terminal marked with
the letter L or coloured red.
WARNING
THIS APPLIANCE MUST BE
EARTHED
Electrical connection
40