Filter
Top Products
When using the unit
Names of parts
Operation
Open
Close
Open
Close
Knob
Operation indicator
Cord
Once
HI operation
(Operation indicator lights.)
Panel
Screw
Cord
Power plug
Air filter
Operation indicator
Main unit
Lossnay Core (Heat exchanger)
Shutter (prevents outside air
being blown in when unit is off)
1. Insert the power plug into the wall outlet.
2. Slide the shutter knob to the left (open) position. (The shutter
must be open for ventilation.)
3. Pull the cord.
When the unit is not operating slide the shutter to the closed position if the weather is windy,dense foggy or snowstorm.
You can open the shutter when the unit is off to use it as a natural ventilation.
Three
times
Off
(Operation indicator
goes out.)
Twice
LO operation
• Do not place objects around the unit.
The air outlet or intake openings may be blocked or servicing of the Lossnay element may become impossible.
It may become impossible to remove the power plug from the wall outlet.
• Do not use aerosol sprays (such as insect sprays, hair sprays or cleansers ) directly on the unit.
The panel may degenerate or become damaged.
• Do not obstruct the panel.
Sufficient ventilation may be impeded.
• Do not pull the cord diagonally.
The unit will not operate correctly.
• To prevent freezing or damage to the Lossnay Core, stop the unit if the outside temperature falls below
-10°C and the room's humidity rises above 40%.
• Use this product in an environment where the internal temperature ranges from 0°C to
+
40°C and the
relative humidity is less than 80%.
Tr oubleshooting
Check the unit if any of the following problems occurs. If the problem is not listed below, or the
problem persists after checking, contact your dealer being sure to first remove the power plug from
the wall outlet.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard. (Contact your dealer.)
Problem Cause Check the following
• Check the power plug.
• Check that a circuit breaker
Unit does not operate. No power to main unit (fuse) has not tripped.
• Check a power failure has
not occurred.
Panel or filter is not attached Re-attach panel or filter.
securely.
Unit is making a strange noise
Filter is clogged. Clean filter.
Shutter is closed. Open shutter.
Less air than normal is coming Filter is clogged. Clean filter.
out of unit. Shutter is closed. Open shutter.