Filter
Top Products
Operating Instructions Safety InstructionsConsumer Support Installation Instructions
Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface.
Clean grease-laden surfaces of the
hood frequently. To clean the hood
surface, use a hot, damp cloth with a
mild detergent suitable for painted
surfaces. About one tablespoon of
ammonia may be added to the
water. Use a clean, hot, damp
cloth to remove soap. Dry with
a dry, clean cloth.
NOTE:
When cleaning, take care not
to come in contact with filters and
other non-enameled surfaces.
CAUTION: When cleaning the
hood surfaces, be certain that you
do not touch the light bulb with moist
hands or cloth. A warm or hot light
bulb may break if touched with a moist
surface. Always let the light bulb cool
completely before cleaning around it.
Painted Surfaces
(on some models)
CAUTION:
Let the light bulb cool
completely before removing. A
warm or hot bulb may break if
touched with a moist cloth or hand.
Remove the bulb and replace with
an ordinary screw-base light bulb,
not more than 60 watts
.
To remove the light cover
(on some models):
• Press the sides with two fingers
until the side prongs are released.
• Lift the light cover and slide it
toward you in one motion.
To replace the light cover:
• Insert the prong located at the
end of the cover into the top
opening.
• Gently push the cover up and
press the sides to fit the side
prongs into the side openings.
• Release and the cover will lock
in position.
Hood Light
The charcoal filter cannot be cleaned.
It must be replaced. Order filter no.
WB02X10700. Replacement filters
can be ordered from your GE supplier.
If the hood is not vented to the
outside, the air will be recirculated
through a disposable charcoal filter
that helps remove smoke and odors.
The charcoal filter should be
replaced after 6 to 12 months
(depending on hood usage).
To remove:
Pull down on the center of the front
edge of the filter. The filter will then
slip out of the retaining tabs on the
back.
To replace:
Slip the back edge of the filter into
the retaining tabs and push the
front edge up until it snaps into
place.
Charcoal Filter—Recirculating Installations Only
Replaceable charcoal filter
4
NOTE: DO NOT rinse, or put charcoal filters in
an automatic dishwasher.
Light cover
Do not use a steel-wool pad; it will
scratch the surface.
To clean the stainless steel
surface, use warm sudsy water or
a stainless steel cleaner or polish.
Always wipe the surface in the
direction of the grain. Follow the
cleaner instructions for cleaning
the stainless steel surface.
To inquire about purchasing
stainless steel appliance cleaner or
polish, or to find the location of a
dealer nearest you, please call our
toll-free number:
National Parts Center 1-800-661-1616
www.moffatppliances.ca
Stainless Steel Surfaces
(on some models)