Filter
Top Products
10
Replacing The Oven Light
Disconnect the appliance.
If the oven bulb needs replacing, it must comply
with the following specifications:
Electric power: 15 W/25 W; Electric rate: 230 V
(50 Hz); Resistant to temperatures of 300°C;
Connection type: E14.
These bulbs are available from your local
Service Force Centre. To replace the faulty
bulb:
1. Ensure the oven is disconnected from the
electrical supply.
2. Turn the glass cover counterclockwise.
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover and restore the
electrical supply.
SYMPTOM
" The oven does not come on
" The oven temperature light does not
come on
" The oven light does not come on
" It takes too much time to finish the dishes,
or they are cooked too fast.
" Steam and condensation settle on the
food and the oven cavity.
SOLUTION
# Check that both a cooking function and
temperature have been selected.
# Check the appliance is wired in properly,
and the socket switch or the switch from the
mains supply to the oven are ON.
# Select a temperature with the thermostat
control knob
# Select a function with the oven function
control knob.
# Select a function with the oven function
control knob
# Check the light bulb, and replace it if necessary
(see paragraph "Replacing The Oven Light")
# The temperature may need adjusting
# Refer to the contents of this booklet,
especially to the chapter “Using the Oven”.
# Leave dishes inside the oven no longer
than 15-20 minutes after the cooking is
completed.
Something not Working
If the appliance is not working correctly, please carry out the following checks, before contacting
your local Service Force Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.