Morphy Richards Kettle Hot Beverage Maker User Manual


 
Using
Filtering your water improves the taste
and appearance of beverages by reducing
limescale, lead, chlorine and other
impurities.
Before use
1 Remove cartridge from the packet and
soak in a bowl of water for 20 minutes.
2 Take the top compartment (the cartridge
holder) out of the kettle by pulling the
cartridge holder easy release button Á
forward and lift upwards.
3 Insert the cartridge into the top
compartment from the bottom and twist
clockwise to lock in place.
4 Replace the cartridge holder back into
the kettle and click into place.
Filling the kettle
1 Fill the kettle with tap water to the
maximum mark either by lifting up the lid
or by sliding the filler slider to one side
as shown.
2 Allow water to filter through system,
discard the water and repeat once more.
The amount of water must cover the
kettle element. The minimum is 1 cup or
30 cls. Do not fill above the maximum
mark or filter performance will be
impaired. Always ensure the kettle is
emptied before refilling.
Electronic cartridge reminder
After changing the cartridge and for first
usage, the counter must be reset.
1 Hold the start button for 3 seconds
(100% will show on the display and the
outer ring will flash). The display will then
switch off due to its energy saving device
after 3 minutes.
2 You can check the progress of your
cartridge at any time by pressing the
start button for 1 second. The counter
will count down from 100% to 25%.
3 25% turns off when the cartridge needs
replacing. The outer ring of the display
will flash and continue to flash until the
cartridge has been changed.
4 Reset the reminder as per point 1.
4