Morphy Richards Kettle Hot Beverage Maker User Manual


 
5
Replacing electronic cartridge reminder
When the cartridge reminder is due for
renewal it can easily be removed.
1 Pull both tabs upwards and lift out the
cartridge reminder.
2 To refit your new cartridge reminder, slot
tabs into the lugs provided and click into
place.
Telephone our replacement parts
helpline for your new cartridge reminder.
Switching on
You do not need to wait until the water
has filtered through before boiling. Your
Morphy Richards filter kettle, will boil and
filter at the same time giving you boiled,
filtered water quickly.
Boil only as much water as you need as
this saves electricity.
1 Place the filter kettle on the base unit,
ensuring the kettle locates on to the
360˚ connector.
The 360˚ connector allows the kettle to
be located at any position, - ideal for left
and right handed users and convenient
positioning on worktop.
2 Plug in and switch on at the wall socket.
3 Switch the filter kettle on. The ‘power on’
neon, will light up.
4 When the water boils the filter kettle will
switch off automatically.
If you are using the kettle for the first
time, discard the water and repeat once
more.
•To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
If you do not put in enough water, or
switch on the filter kettle when it is
empty, the safety cut-out will switch off
the power automatically. If this happens,
refill and wait a few minutes for the
element to cool, then use as normal.
5 Lift the filter kettle from the base unit by
the handle ensuring you hold the kettle
level.
WARNING: Unless the cartridge holder
is fitted correctly, the filter kettle may not
operate correctly and the lid may not
close and lock securely.