Moyer Diebel 201HTN Dishwasher User Manual


 
12
Chemical Dispensers
Initial Start-up
1. Make sure the chemical containers are full and the correct pick-up tubes are in the
containers.
2. Turn the dishwasher power switch ON. The switch will illuminate and the dishwasher
will ll with water.
3. The Prime push button primes the Sanitizer pump and the Rinse-aid pump.
The Detergent pump does not have a prime push button. During normal operation,
observe the detergent pick-up tubing to make sure that air bubbles are moving
through the tubing which indicates that the detergent is being dispensed.
4. Open the dishwasher door, then push and hold the prime push button UP to the
SANI position until sanitizer enters the wash tank compartment. Release the PRIME
push button.
5. Push and hold the Prime push button DOWN to the RINSE position until rinse-aid
is observed entering the wash tank compartment. Release the Prime push button.
6. Priming is complete.
1. Make sure the chemical containers are full and the correct pick-up tubes are in the
containers.
2. Turn the dishwasher power switch ON. The switch will illuminate and the
dishwasher will ll with water.
3. Open the dishwasher door, then push and hold the prime push button UP to the
DET position until detergent is observed entering the wash tank compartment.
4. Push and hold the prime push button DOWN to the RINSE position until rinse-aid
enters the wash tank compartment. Release the push button.
5. Priming is complete.
Priming the Chemical Dispensing Pumps
Models 501HT, 501HTN, 401HT, 401HTN, 201HT, 201HTN
Models 501LT, and 201LT
PRIME
DET
R/A
Prime Switch
Model Series 501
I
O
START POWER
PRIME
OFF / DRAIN
ON
DET
R/A
Prime Switch
Model Series 401, 201