Moyer Diebel 401-HTN Dishwasher User Manual


 
INSTALLATION
7
Completing Installation
1. Remove any foreign material from inside the machine.
2. Center the scrap screen over the sump opening.
3. Prime the booster using the following procedure (if applicable).
CAUTION:
To prime the booster, the following procedure must be followed AFTER the electrical
and plumbing connections have been made and water has been turned on.
a. Open the dishwasher door.
b. Make sure the On-Fill/Off-Drain switch is in the Off-Drain position.
c. Push the Detergent/Rinse prime switch “down” to the Rinse position.
d. Hold the prime switch in the Rinse position until you observe water entering the wash
tank. The water inlet port is on the lower right side of the tank interior.
e. Release the switch. You have completed the booster priming process.
WARNING:
Failure to prime the booster may cause damage to the booster
elements and other electrical components and will void the
warranty.
4. Check the machine for water leaks by depressing the ON/FILL switch on the front panel,
then close and latch the door. This allows the tank to automatically fill by using the rinse
cycle. Check for leaks.
5. Open the door and check the water level. The water level should be 1/2" over the scrap
screen.
6. Depress the OFF/DRAIN switch, close and latch the door to drain the machine. This allows
the machine to complete the 105-second wash and drain cycle. Check the drain plumbing
for leaks or kinks in drain hose.
7. Replace the front panel. Installation is now complete.
!
!
IN
CYCLE
OFF
DRAIN
ON
FILL
DET
RINSE
00034